Manufacturer of a wide range of products which include belt rupture tear switch and belt tear switch.
Belt Rupture Tear Switch
Get Best Quote
Approx. Price: Rs 23,500 / PieceGet Latest Price
Current Rating (In Amps)
Up to 55 Degrees
110/ 230 Volt
Automatic / Manual
Adjustable up to 3 meters
Catering to the diverse demands of our clients, our organization is offering a quality range of Belt Rupture Tear Switch.
Easy to install & may be mounted in any position with noncritical alignment between sensors.
Switches are provided for blanking/by-passing individual channels.
Belt rupture sensor operates on micro-controller based cyclic scanning
Photo-electric infra-red techniques.
Various sensing range are available from covering 100mm to 1000mm conveyor width.
Use of solid-state components & special construction technique ensures that sensors is not affected by normal vibrations & shocks.
For sensors, connections are provided through plug in connectors. SSelf-checkingCircuitry continuously monitors failure of any of the beam in the system and stops the convoy. if failure detected.
LED Indications are provided for status indication of each channel
LED Indication for output and sense.
Adjustable nuisance tripping delay
Sai Control System offers new generation Belt Rupture/Rip switch which is based on advanced micro controller technology. Belt rupture Switch consist of controller and optical transmitter and receiver for sensing. Sensor to be mounted below the belt of the conveyor. If the belt is ruptured or ripped then the conveying material will fall in the sensing area of the sensor and it will sense the falling material and the controller will trip the belt conveyor.
We are offering Belt Tear Switch. Designed in tune with the latest technology; the given product is used in various industrial applications for switching power on or off. These are available with us in various sensing range and are non-corrosive in nature. Feature:
With belt rupture sensor
Easy to use
The monitoring units are to be fixed in inclined position in the direction of the belt movement.The unit is provided with two 5meter long rope lengths. Appropriate length to be cut while fixing the rope. The splinters, resulting from tearing of the belt, will push out the cross-connected sensing rope to accurate the switch. The potential free contacts of the switch are to be wired into appropriate warning/tripping circuit. The switch can be reset by operating the reset lever. Rope to be manually refixed in position while re-starting the belt operation.
A set consists of Pair of monitoring units with mounting frame.